shotslasas.blogg.se

Char griller super pro 29
Char griller super pro 29




  1. CHAR GRILLER SUPER PRO 29 SERIAL NUMBER
  2. CHAR GRILLER SUPER PRO 29 INSTALL
  3. CHAR GRILLER SUPER PRO 29 MANUAL

USE OUTDOORS ONLY ON NONCOMBUSTIBLE SURFACE – 15’ AWAY FROM WOOD AND COMBUSTIBLE MATERIAL.ģ. ALWAYS FOLLOW CHARCOAL AND LIGHTER FLUID MANUFACTURERS’ INSTRUCTIONS AND WARNINGS. If one end burnsįaster, use tongs to move coals from one end to the other for even heat. Light coals in several places, close lid after briquettes ash over or _ gray, spread them out and start cooking. To START FIRE – stack 50-60 briquettes in pyramid and saturate with lighterįluid (DON’T USE GASOLINE). THIS UNIT IS NOT WARRANTED AGAINST RUST.Ģ. NEVER EXCEED 400 BECAUSE THIS WILL DAMAGE THE FINISH AND CONTRIBUTE TO RUST. NOTE: Grill will drip a lot of oil during this process and for several Will extend the life of the finish, much like waxing a car. YouĬan lightly coat the exterior of the grill body (while warm) with vegetable oil. Re-coat GRATES and return to grill at approximately 200 F for two hours. Replace cooking grates, close lid and heat at approximately 250 F for two hours. (C) After coals ash over, spread out coals, (B) BuildĪ medium sized fire on the fire grate. Oil (spray vegetable oil is easiest but do not use near hot coals or fire). SURFACES (including GRILLS, GRATES, AND INSIDE OF BARREL.) with vegetable To prevent unnatural flavors to your first meals. Cure GRILL prior to your initial use to protect the interior and exterior finish and Read all safety warnings and instructions carefullyīefore assembling and operating your grill.ġ.

  • GRILL PREPARATION &OPERATING INSTRUCTIONS.
  • Side Shelf Slab at the front of the Grill.

    CHAR GRILLER SUPER PRO 29 INSTALL

  • Step 13: Place Cooking Grates onto Grill Body then Install the Utensil Hooks underneath each.
  • Step 12: Place Ash Pan and Ash Pan Hangers onto Grill Body. Then Position the Warming Rack onto the Hex Bolts and Secure it with two more Hex Nuts. And attach two (2) ¾” Hex Bolts and two (2) Hex Nuts onto the Grill Body.
  • Step 11: To install the Warming Rack first attach two (2) 2” Hex Bolts and two (2) Hex Nuts.
  • Step 10: Attach Front Shelf to Grill Body with four Hex Bolts and four (4) ¾” Hex Nuts.
  • Step 9: Attach Side Shelf to Grill Body with four Hex Bolts and four (4) ½” Hex Nuts.
  • Grill Hood then secure it with two ¾” Hex Bolts and two Hex Nuts. Step 8: Insert Smokestack Assembly through the hole on the Grill Hood from the inside of the Then attach Hood Handle to the Grill Hood with two 3/4" hex bolts, two lock washers,
  • Step 7: Insert Thermometer through hole in Bezel and Grill Hood (from outside) and secure with.
  • char griller super pro 29

    Step 6: Attach the Grill Hood to the Grill Body using the two Hinge Pins and two Cotter Pins Step 5: Attach Damper Circle to the side of the Grill Body with one ¾” Hex Bolts, two Flat Washers, one Lock Washer, and one Hex Nut.The Bolts must go through the leg, Grill Body then tighten with the Hex Nuts inside Step 4: Attach the Grill Body to the previous assembly cart using four 1 3/4” Hex Bolts and four Complete the assembly by sliding the other Wheel onto Axle then insert

    char griller super pro 29

    Slide one Wheel onto the Axle then slide the Axle through the holes on the Short On one end of the Axle insert the Cotter Pin into the hole on the Axle and snap in

  • Step 3: Lay the cart assembly down with the Long Legs on the floor then install the Wheels and.
  • Then rotate the leg assemblies up and secure the Leg Braces to the other side of the Long LegĪnd Short Leg set with four (4) 1¾” Hex Bolts and four (4) Hex Nuts. Step 2: Install Bottom Wire Shelf by placing the four corner hooks inside the hole on each leg Step 1: Assemble Long Legs, Short Legs, and Leg Braces as show below then secure the Legīraces to one set of Long Leg and Short Leg with four (4) 1¾” Hex Bolts and four (4) Hex Nuts. IMPORTANT HINT: DO NOT TIGHTEN ANY NUTS AND BOLTS UNTIL Read all safety warnings and instructions carefully before

    char griller super pro 29

    CHAR GRILLER SUPER PRO 29 SERIAL NUMBER

    Have your grills serial number (located on the back of the grill body or on the leg) Or A&J Manufacturing is strictly prohibited.ĬALL (912) 638-4724 This product has been built to the highest quality standards.Ĭall us should you have any questions not addressed in these instructions, or for

    CHAR GRILLER SUPER PRO 29 MANUAL

    Using the information contained in this manual without consent of Char-Griller and/ Keep your receipt with this manual for Warranty.ĬUSTOMER of this manual are Trademarked and Copyrighted by Char-Griller | A&J Manufacturing. 605, SANTA ENGRACIA, SAN PEDRO GARZA GARCÍA, NUEVO LEÓN, MÉXICO CP 66267






    Char griller super pro 29